|
The RD series amplifiers deliver a ton of power with a low distortion rate. We used the best parts we could find to give you a top quality amplifier that anyone would be proud to show off. With their clean looks and sleek finish, they’ll look good in any install. So whether it’s an elegant sound quality setup or a high powered SPL vehicle, the RD series amplifiers have you covered.
Features
- Digital class-D linkable mono block amplifier
- MOSFET PWM power supply
- Daisy-chain through output RCA
- Double sided through hole epoxy PCB
- Stable into 1 ohm and 2 ohm parallel amplifier connection availability
- 24dB/oct variable crossover
- Variable subsonic filter
- Variable bass boost
- Variable low pass filter
- Variable phase shift
- Efficiency : 86% @ 4 ohm, at 100Hz
- Multi-way protection circuitry (Thermal/over current/speaker short/speaker dc protection)
- RCA line input
- Tested voltage & THD : 14.4V & less than 1% THD
- Operating voltage : DC 10V~18V power input- 2008 models
- Wired remote controller
MSRP
$1399.00
Specifications
| RMS power, 2 ohm linkable/dual mono |
5600w x 1ch |
| RMS power, 0.875 ohm mono |
3750w x1ch |
| RMS power, 1 ohm mono |
3000w x1ch |
| RMS power, 2 ohm mono |
1500w x1ch |
| RMS power, 4 ohm mono |
750w x1ch |
| Signal to Noise Ratio |
>100dB |
| Low pass frequency crossover |
35Hz~300Hz |
| Subsonic filter |
10Hz~60Hz |
| Bass boost @ 45Hz |
0~18dB |
| Phase shift control |
0~180 degree |
| Frequency response |
10Hz~350Hz (+/- 1dB) |
| T.H.D @ 4 ohm |
<0.1% |
| Efficiency @ 4 ohm |
86% |
| Fuse rating |
300A(external type fuse - not included) |
| Input Sensitivity |
200mV to 6V (+/- 5%) |
| Dimensions |
222(W) x 52(H) x 590(L)mm |
Click for product manual ››
|
