|
The RD series amplifiers deliver a ton of power with a low distortion rate. We used the best parts we could find to give you a top quality amplifier that anyone would be proud to show off. With their clean looks and sleek finish, they’ll look good in any install. So whether it’s an elegant sound quality setup or a high powered SPL vehicle, the RD series amplifiers have you covered.
Features
- Digital class-D linkable mono block amplifier
- MOSFET PWM power supply
- Daisy-chain through output RCA
- Double sided through hole epoxy PCB
- Stable into 1 ohm load workable
- 24dB/oct, fully variable low pass (LPF) crossover
- 24dB/oct, fully variable subsonic filter
- 18dB/oct, fully variable adjustable bass-boost
- Variable frequency for bass boost
- Efficiency: 86% @ 4 ohm, 100 Hz
- Multi-way protection circuitry (Thermal/over current/speaker short/speaker dc protection)
- RCA line input
- Tested voltage & THD : 14.4V & less than 1% THD
- Operating voltage : DC 10V~16V power input
- Wired remote controller
MSRP
$399.00
Specifications
| RMS power, 1 ohm mono |
550w x 1ch |
| RMS power, 2 ohm mono |
350w x 1ch |
| RMS power, 4 ohm mono |
200w x 1ch |
| Signal to Noise Ratio |
>100dB |
| Low pass frequency crossover |
35Hz~300Hz |
| Subsonic filter |
10Hz~60Hz |
| Bass boost @ 45Hz |
0~18dB |
| Bass boost control |
35Hz~120Hz |
| Frequency response |
10Hz~350Hz (+/- 1dB) |
| T.H.D @ 4 ohm |
<0.1% |
| Efficiency @ 4 ohm |
86% |
| Fuse rating |
20A x 3 |
| Input Sensitivity |
200mV to 6V (+/- 5%) |
| Dimensions |
222(W) x 52(H) x 270(L)mm |
Click for product manual ››
|
